Dynojet 250i: Installation Guide - Manual (Page 43)

I N S T A L L A T I O N
Support Arm and Monitor Tray
Version 5 Model 200i and 250i Motorcycle Dynamometer Installation Guide
2-21
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
SUPPORT ARM AND MONITOR TRAY
This articulated arm and platform supports the monitor, keyboard, and mouse in a
convenient position for operation while seated on the motorcycle. The support arm
can be mounted on either side of the dynamometer.
P ARTS L IST
The following table lists all of the parts included in the Monitor Stand Installation kit.
Check your kit against the parts listed to make sure you have received all of the parts.
If any part is missing, contact Dynojet Technical Support.
I NSTALLING THE S UPPORT A RM AND T RAY
The support arm and monitor tray may be installed on either side of your dyno.
1
Remove the four 3/8-16 x 1/2-inch button-head flange screws from the dyno
where you plan to install the support arm.
2 Using an allen wrench, secure the support arm to the dyno frame with four
3/8-16 x 1/2-inch button-head flange screws you removed earlier.
3 Place a poly washer around the pin of the first arm and insert the arm into the
support arm.
4 Place a poly washer around the pin of the second arm and insert the arm into the
first arm.
5 Place a poly washer around the pin of the tray and insert the tray into the second
arm.
6 Insert a plastic cap in both ends of each arm.
7 Check for clearance between the monitor arm and motorcycle, walls, ceiling, etc.
Note: Dynojet does not recommend placing the computer CPU on the
monitor/keyboard tray since vibration can cause damage to the computer.
part number description quantity
21229300 Monitor Arm Tray 1
32391064 Bushing, 1" x 2", 10 Gauge, Stl 3
35521420 Plastic Cap, 1.75" x 1/2", Black 4
36701100 Nut, 1/2-13, Hex 2
36801253 Screw, 1/2-13 x 1.5", Sh-Cap 2
36932100 Washer, 3/8", Splitlock, Stl 1
36942100 Washer, 1/2", Splitlock, Stl 2
36943100 Washer, 1/2", Flat, Stl 4
61329100 Monitor Arm 2