Dynojet 250i: Installation Guide - Manual (Page 75)

A C C E S S O R I E S
Air Brake
Version 5 Model 200i and 250i Motorcycle Dynamometer Installation Guide
3-9
5 Route the air hose from the air brake through the access hole in the drum module
upright, under the carriage frame brace, and connect to the bulkhead fitting at the
front of the dyno.
6 You will need to provide an air hose nipple (1/4-inch NPT) to connect your clean,
dry shop air supply (60 psi, 415 kilopascal, max constant line pressure) to the
dynamometer.
Figure 3-8: Connect the Air Hose
air brake
air hose
bulkhead fitting
access hole