Dynojet 250i: Installation Guide - Manual (Page 52)

Model 200i and 250i Motorcycle Dynamometer Installation Guide
C H A P T E R 2
Routing Cables
2-30
R OUTING THE E DDY C URRENT B RAKE C ABLES
With the center panel off, now is a good time to connect and route the theta
controller cables. You will only have a theta controller if you installed the optional
eddy current brake accessory, see Figure 2-21 on page 2-20.
1
Attach the input power cable (P/N 66952004) to the top of the theta controller.
2 Route the eddy current brake cable (P/N 66952003) from the eddy current brake
to the bottom of the theta controller.
3 Route the control cable from the theta controller out of the side of the dyno
chassis to the Breakout board through the hole in the CPI shown in Figure 2-31.
4 Route the temperature sensor cable from the eddy current brake through the air
hole in the drum bulkhead, through the opening on the side of the CPI, and over
to the Breakout board.
Note: For more information on wiring the Breakout board refer to page 2-31.
Figure 2-31: Route the Eddy Current Brake Cables
EB148
breakout board eddy current brake cable
temperature
sensor cable theta controller
air hole in drum
bulkhead
control cable
input power