Dynojet 250i: Installation Guide - Manual (Page 31)

I N S T A L L A T I O N
Dyno Installation
Version 5 Model 200i and 250i Motorcycle Dynamometer Installation Guide
2-9
P OSITIONING AND S ECURING THE D YNO
1 Gently lower the dyno into position. Be sure the location you have chosen for
your dyno has enough room in front of the dyno for the maximum extension of
the carriage. Refer to “Dynamometer Specifications and Requirements” on page 1-
5 for more information.
2 Secure the dyno to the floor in your dyno room.
Note: Skip this step if you will be installing the eddy current brake. Install the
eddy current brake first, and then secure the dyno and the eddy current brake to
the floor.
Dynojet recommends you secure your dyno to the floor in your dyno room using
concrete anchors. You will want to mark and drill the holes in your concrete
before adding any accessories or replacing the covers on your dyno.
2a
Mark and drill holes.
2b Install the Red Head anchors according to the instructions in Appendix A.
Figure 2-9: Anchor Hole Placement
MC118
mark and drill holes
hole not visible from
this view
mark and drill hole