Dynojet 250i: Installation Guide - Manual (Page 71)

A C C E S S O R I E S
Remove and Replace Dyno and Drum Covers
Version 5 Model 200i and 250i Motorcycle Dynamometer Installation Guide
3-5
R EMOVING THE C ENTER P ANEL
1 Remove the four 1/4-20 x 5/8-inch pan head screws securing the bearing bracket
to the tire carriage and set aside.
2 Using the hand crank, unscrew the bearing bracket and the carriage screw and set
aside.
3 Remove the tire carriage by sliding the carriage under the carriage clamps toward
the back of the dyno and set aside.
Figure 3-4: Remove the Tire Carriage
hand crank
carriage screw
screws
carriage clamp
tire carriage
bearing
bracket