Arc Machines 207 - Manual (Page 44)

MODEL 207A AND 207A-1
OPERATION MANUAL
Doc. No. 740044
Rev F
SECTION V - OPERATION
5.7
SET UP FUNCTIONS
1. SET UP FUNCTIONS IN OPERATE MODE
8. WELD DATA RECORDING (WDR) - Selecting this feature will access
another screen that will allow the user to turn on WDR and/or turn on
WELD ID recording.
From this screen WDR STORAGE can be selected as “NOT SAVED” or
“PCMCIA”. If “NOT SAVED” is selected then WDR is turned OFF and
operation is normal. If “PCMCIA” is selected then the system will request
a WELD ID be entered at the beginning of sequence and will record the
weld data into a PCMCIA card at the end of sequence. This PCMCIA
card can be used in conjunction with AMI OLP PC software to be used for
Weld Record Data keeping.
From the same screen WELD ID can be selected as “NOT PROMPTED”
or “PROMPTED”. It can be set to “PROMPTED” anytime. However,
if WDR STORAGE is set to PCMCIA then WELD ID automatically
defaults to “PROMPTED” and cannot be changed When set to prompted
it will require that the WELD ID be entered at the beginning of sequence.
This weld ID will be recorded in the PCMCIA card (if WDR is on) and
will appear on the Weld Schedule Print if printed at the end of sequence.
9. OPERATOR ID / NAME - This feature will allow the operator to enter his
ID number or name. If entered it will appear on the weld schedule print
out at the end of sequence (if printed) and it will be recorded by Weld
Data Recording onto a PCMCIA card if that feature is being used. Once
entered it will be remembered by the system as the operator until it is
cleared.
10. SERIAL NUMBER - This feature will allow the operator to enter the
Power Supply Serial number. If WDR is being used the Serial Number
information will be recorded in the PCMCIA card for use with OLP.
5.9