HP 49g Graphing Calculator - Manual (Page 17)

Command catalog
The HP 49G provides a single choose list that contains all its commands.
This is called the command catalog.
Displaying the command catalog
RAD
■ : hoh
CATAlD(i: 6S3 CtiHHADDS
K
HCH
¿1
isnsiKn
1. Press
A choose list is displayed. This is the
command catalog.
2. Locate the command that you want to
enter. (See the next section.)
3. Press
OK
or (MS)-
If you are working in algebraic mode, the command you selected
appears on the command line ready for you to specify arguments.
If you are working in RPN mode, the result of the conunand appears on
the stack.
Locating a command in the command catalog
There are two ways to locate a conunand in the command catalog;
® by scrolling
® by searching on the first character or first few characters of the
command.
Scrolling through the catalog
To scroll through the command catalog, press the (3 or ( a ) keys. Keep
doing so until the command you want is highlighted.
You can use the shift keys in conjimction with the arrow keys to scroll
more quickly through the catalog. For example:
0® displays the last command in the catalog
0® displays the first conunand
0® displays the next page of commands
0® displays the previous page of conunands.
The niunber of commands displayed per page is determined by flag -90.
When set—which is the default—the commands are displayed in the mini­
font. This gives you six conunands per page. If flag -90 is cleared, the
Page 1-4 Entering commands