Notes on charging the battery pack, To remove the battery pack, Note on battery terminal cover – Sony DCR-PC1 User Manual

Page 9: Charging and installing the battery pack

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Charging and installing the battery pack

Notes on charging the battery pack

• The CHARGE lamp will remain lit for a while even if the battery pack is removed

and the power cord is unplugged after charging the battery pack. This is normal.

• If the CHARGE lamp does not light, disconnect the power cord. After about one

minute, reconnect the power cord again.

• When a fully charged battery pack is installed, the CHARGE lamp will light once,

then go out.

(1)

Set the roWER switch' to OFF to prevent misoperation of the camcorder.

(2)

While sliding ВАТТ RELEASE in the direction of the arrow

slide the battery

terminal cover in the direction of the arrow O-

(3)

Insert the battery pack in the direction of the arrow.

To remove the battery pack

The battery pack is removed in the same way as the battery terminal cover.

Note on battery terminal cover

To protect the battery terminals, install the battery terminal cover after the battery pack
is removed.

You can look at the demonstration of the functions available with this camcorder (p. 28).