Sony DCR-PC1 - Manual (Page 7)

Getting started
Charging and installing the battery pack
Before using your camcorder, you first need to chargg_and install the battery pack. To
charge the battery pack, use the supplied AC power adaptor.
This camcorder operates only with die "InfoLITHIUM" battery pack (S series).
"InfoLTTHIUM" is a trademark of Sony Corporation.
(1) Connect the power cord to the AC power adaptor.
(2) Align the hooks of the battery pack with the AC power adaptor. Then fit the battery
pack in the direction of the arrow.
(3) Connect the power cord to a wall outlet. The CHARGE lamp (orange) lights up.
Charging begins.
When the CHARGE lamp goes out, normal charge is completed. For full charge,
which allows you to use the battery longer than usual, leave the battery pack in place
for approximately one hour after the CHARGE lamp goes out. Unplug the unit from the
wall outlet, then remove the battery pack and install it into the camcorder. You can also
use the battery pack before it is completely charged.
Charging time
Battery pack Charging time *
NP-FIO (supplied) 145 (85)
NP-F20 220 (160)
NP-F30 295 (235)
The time required for a normal charge is indicated in parentheses.
Only the battery packs listed above can be used with this camcorder.
* Approximate minutes to charge an empty battery pack using the supplied AC power
adaptor. (Lower temperatures require a longer charging time.)