Sony DCR-PC1 - Manual (Page 24)

■ Advanced operations
Using alternative power sources
You can choose any of the following power sources fo^your camcorder: battery pack
and house current. Choose the appropriate power source depending on where you
want to use your camcorder.
Place Power source Accessory to be used
Indoors House current Supplied AC power adaptor
Outdoors Battery pack Battery pack NP-FIO (supplied), NP-F20, NP-F30
Note on power sources
Disconnecting the power source or removing the battery pack during recording or
playback may damage the inserted tape. If this happens, restore the power supply
again immediately.
Using the house current ^
To use the supplied AC power adaptor;
(1) Connect the supplied connecting cord to the DC OUT jack on the AC power adaptor.
(2) Slide the connecting plate in the direction of the arrow.
(3) Connect the power cord to the AC power adaptor.
(4) Connect the power cord to a wall outlet.
To remove the connecting plate
The connecting plate is removed in the same way as the battery pack.
WARNING
The power cord must only be changed at a qualified service shop.
PRECAUTION
The set is not disconnected from the AC power source (mains) as long as it is cormected
to a wall outlet, even if the set itself has been turned off.
This mark indicates that this product is a genuine accessory for Sony
video product.
When purchasing Sony video products, Sony recommends that you
purchase accessories with this "GENUINE VIDEO ACCESSORIES" mark.