Returning to a pre-registered position, Note on the tape counter, Notes on zero set memory – Sony DCR-PC1 User Manual
Page 65
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Returning to a pre-registered position
Using the Remote Commander, you can easily go bai^to the desired point on a tape
after playback.
(1) During playback, press ZERO SET MEMORY at the point you later want to locate.
The counter shows "0:00:00" and "ZERO SET MEMORY" appears on the LCD
screen or in the viewfinder.
(2) Press ■ when you want to stop playback.
(3) Press -<4 to rewind or press ►► to fast-forward the tape to the counter's zero point.
The tape stops automatically when the counter reaches approximately zero. "ZERO
SET MEMORY" disappears and the time code appears.
(4) Pressé.
>
a.
• 0:12:34:00
*!► 0:00:00:00
40m inB
>ZERO SET
‘ ~ kiK M O R Y .
■^/11 l l » \
Note on the tape counter
There may be a discrepancy of several sdConds from the time code.
Notes on ZERO SET MEMORY
• When you press ZERO SET MEMORY, the counter's zero point is memorized. Press
ZERO SET MEMORY again before step 3 to cancel the memory.
• ZERO SET MEMORY may not function when there is a blank portion between
.pictures on a tape.
• ZERO SET MEMORY functions also in recording standby mode.