Inserting a cassette, To eject the cassette, To prevent accidental erasure – Sony DCR-PC1 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
![background image](/manuals/631347/10/background.png)
Inserting a cassette
You can use mini DV cassette with “"IV logo* only. ^
Make sure that the power source is installed.
(1) Slide A OPEN/EJECT in the direction of the arrow
O
and open the lid in the
direction of the arrow
Q.
The cassette compartment automatically lifts up and
opens.
(2)
Push the middle portion of the back of the tape to insert a cassette.
Insert the cassette in a straight line deeply into the cassette compartment with the
window facing out.
(3)
Close the cassette compartment by pressing the
ipushi
mark on the cassette
conipartment. The cassette compartment automatically goes down.
(4)
After the cassette compartment going down completely, close the lid until it clicks.
*
is a trademark.
To eject the cassette
Follow the procedure above and in step 2, take out the cassette.
Notes
• Do not put forcibly the cassette into the-cassette compartment. Doing so may damage
the camcorder.
• When you open the lid immediately after you install the battery, the cassette
compartment may not open. Close the lid and open it again.
• The cassette compartment may not be closed when you press any part of the lid other
than the
(
push
I
mark.
• Be careful not to get your fingers caught in the cassette lid.
• When you insert and eject a cassette, set the POWER switch to OFF to prevent
misoperation of the camcorder.
To prevent accidental erasure
Slide and open the tab on the cassette to expose the red mark. If you try to record with
the red mark exposed, the and
A
indicators flash on the LCD screen or in the
viewfinder, and you cannot record on the tape. To re-record on this tape, slide and
close the tab to cover the red mark.