To play back the new recorded sound, Notes on audio mix, To end audio mixing more precisely – Sony DCR-PC1 User Manual
Page 71
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Audio dubbing
ìtè“ ^ rtfrrt f rr-,
(1) Insert your recorded tape into the camcorder.
(2) While pressing the small green button on the POWER switch, set it to VTR.
(3) On the camcorder or Remote Commander, locate the point where the recording
should begin by pressing ◄◄ or Then press II to set it to playback pause mode.
(4) Press AUDIO DUB on the Remote Commander. .Cl I (green) mark appears in the
viewfinder or on the LCD screen.
(5) Press II on the CiUncorder or Remote Commander and at the same time start playing
back the audio you want to record. The new sound will be recorded in stereo 2. The
recorded sound in stereo 1 is not heard. While adding an audio soimd,
C
(red)
mark appears in the viewfinder or on the LCD screen.
(
6
)
Press ■ on the camcorder or Remote Comm^mder at the point where you want to
stop recording.
To play back the new recorded sound
Adjust the balance between the origiiul sound (STl) and the new sound (ST2) by
selecting AUDIO MIX in the menu system.
9RETURN STl
Notes on AUDIO MIX
Five minutes after when you discoimect the power source or remove the battery pack,
the settings of AUDIO MIX return to thè original sound (STl) only. The factory setting
is original sound only.
To end audio mixing more precisely
First playback the tape and press ZERO SET MEMORY on the Remote Conunander at
the point where you want to stop audio mixing. Then start recording from step 2. The
recording stops automatically at the point where you pressed ZERO SET MEMORY.