beautypg.com

Inserting a scene from a vcr, To change the insert end point, Note – Sony DCR-TRV10 User Manual

Page 61: When the inserted picture is piayed back

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Inserting a scene from a VCR

(1)Set the POWER switch to VTR.

(Z)On the VCR, locate just before the insert start point

[a],

then press

II

to set the VCR

to the playback pause mode.

(3) On your camcorder, locate the insert end point [cj by pressing

or Then

press

II

to set it to the playback pause mode.

(4) Press ZERO SET MEMORY on the Remote Commander. The ZERO SET MEMORY

indicator flashes and the end point of the insert is stored in memory.

(5)

On

your

camcorder,

locate

the

insert

start

point

[b]

by

pressing

•♦4,

then

press

two

REC

buttons

at

same

time

to

set

your

camcorder

to

the

recording

pause

mode.

(6)

First press

II

on the VCR, and after a few seconds press

II

on your camcorder to

start inserting the new scene.

Inserting automatically stops near the zero point on the tape counter. Your

camcorder automaticallyrotums to the recording pause mode.

ZERO SET

MEMORY

0

:

00:00

''feROSET'
f , MEMORY,

To change the insert end point

Press ZERO SET MEMORY again after step 5 to erase the ZERO SET MEMORY

indicator and begin from step 3.

Note

The picture and sound recorded on the section between the insert start and end points

will be erased when, you insert the new scene.

When the inserted picture is piayed back

The picture and sound may be distorted at the end of the inserted section. This is not a

malhmction.

To insert a scene without setting the insert end point

Skip step 3 and 4. Press ■ when you want to stop inserting.

60

This manual is related to the following products: