Using the data code function, Not to display various settings, Note – Sony DCR-TRV10 User Manual
Page 26: Recording data, Data code, Playing back a tape
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Playing back a tape
'ri-) 1
*
.
'
l ) ¿ 1 t'iV
i
'
à
'
i
KHO
i
*
Press DISPLAY on your camcorder or the Remote Conunander supplied with your
camcorder.
The indicators appear on the LCD screen.
To make the indicators disappear, press DISPLAY again.
DISPLAY
Using the data code function
Your camcorder automatically records not only images on the tape but also the
recording data (date/time or various settings when recorded)
(Data code).
You can only operate with the Remote Commander.
Press DATA CODE on the Remote Commander in the playback mode.
The display changes as follows:
date/time —► various settings (SteadyShot, white balance, gain, shutter speed, aperture
value) —► no indicator
^ AUTO
JUL 4 IMS
so AWB
12H)S:S6 AM
Not to display various settings
Set DATA CODE to DATE in the MENU settings (p. 72).
The display changes as foEows:
date/time —► no indicator
Note
The pictures taken on the Memory Stick are not recorded with various settings.
Recording data
Recording data is your camcorder's mformation when you have recorded. In the
recording mode, the recording data wiU not be displayed.
When you use data code function, bars (----------) appear if:
• A blank section of the tap>e is being played back.
• The tape is unreadable due to tape damage or noise.
• The tape was recorded by a camcorder without the date and time set.
Data code
The data code is displayed on the TV screen if you connect your camcorder to the TV
(p. 28).