Step 1 preparing the power supply – Sony DCR-TRV10 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Step 1 Preparing the power supply
Use the battery pack after chargmg It for your camcorder.
Your camcorder operates only with the "InfoLITHIUM" battery pack (M series).
"IidoUTHIUM" is a trademark of Sony Corporation.
(1)
Open the DC
IN
jack cover and connect the AC power adaptor supplied with
your camcorder to the DC IN jack with the plug's
A
mark facing up.
(2)
Connect the power cord to the AC power adaptor.
(3)
Connect the power cord to a wall outlet.
(4)
Set the POWER switch to OFF. Charging begins. The remaining battery time is
indicated in minutes on the_display window.
When the remaining battery indicator changes to
normal charge
is completed. To
fully charge the battery
(full charge),
leave the battery pack attached for about 1 hour
after normal charge is completed until FULL appears in the display window. Fully
charging the battery allows you to use the battery longer than usual.
4
1
10