Sony DCR-TRV10 - Manual (Page 29)

Viewing the recording on TV
Once you connect the AV cordless IR receiver (not supplied) to your TV or VCR, you
can easily view the picture on your TV. For details, refer to the operating instructions of
the AV cordless IR receiver.
LASER UNK
LASER LINK emitter
ai
•<
O'
0>
2
a
(1)
After connecting your TV and AV cordless IR receiver, set the POWER switch
on the AV cordless IR receiver to ON.
(2)
Turn the TV on and set the TV/VCR selector on the TV to VCR.
(3)
Press LASER LINK. The lamp of LASER LINK lights up.
(4)
Press ► on your camcorder to start playback.
(5)
Point the LASER LINK emitter at the AV cordless IR receiver. Adjust the
position of your camcorder and the AV cordless IR receiver to obtain clear
playback picliues.
To cancel the laser link function
Press LASER LINK. The lamp on the LASER LINK button goes out.
If you turn the power off
Laser link turns off automaticaU'y.
If you use a Sony TV ' '
• You can turn on the TV automatically when you press LASER LINK or ►•. To do so,
set AUTO TV ON to ON in the MENU settings and turn the TV's main switch on, then
do either of the following:
- Point the LASER LINK emitter at the TV's remote sensor and press LASER LINK.
- Turn on LASER LINK and press
• You can switch the video input of the TV automatically to the one which the AV
cordless IR receiver is connected. To do so, set AUTO TV ON to ON and TV INPUT to
the same video input (1,2,3) in the MENU settings. With some models, however, the
picture and sound may be disconnected momentarily when the video input is
switched.
• The above feature may not work on some TV models.
Note
When laser link is activated (die LASER LINK button is lit), your camcorder consumes
power. Press LASER LINK to turn off the laser link function when it is not needed.