Dell PowerVault 124T - Manual (Page 63)

0000000000000100
Drive TAflag[57]
Automation Interface
Failure
TapeAlert Log Entry:
0000000000000080
The tape drive has a problem
with the automation interface.
The drive has
identified an interface
fault.
Check the power to the
automation system.
Check the cables and
cable connections.
Drive TAflag[58]
Firmware Failure
TapeAlert Log Entry:
0000000000000040
The tape drive has reset itself
due to a detected firmware fault.
Firmware issue
encountered.
Not supported.
Drive TAflag[59]
WORM Medium -
Integrity Check
Failed
TapeAlert Log Entry:
0000000000000020
The tape drive has detected an
inconsistency during the WORM
medium integrity checks.
WORM cartridge may
have been tampered
with.
Replace WORM medium.
Drive TAflag[60]
WORM Medium -
Overwrite Attempted
TapeAlert Log Entry:
0000000000000010
An attempt had been made to
overwrite user data on WORM
medium.
The application
software does not
recognize the medium
as WORM.
If a WORM medium was
used inadvertently,
replace it with a normal
data medium.
If a WORM medium was
used intentionally:
- check that the
software application is
compatible with the
WORM medium format
you are using.
- check that the
medium is bar-coded
correctly for WORM.
Returning the Autoloader for Service
If you need to return the autoloader or a component of the autoloader for service, see Contacting Dell . The
following steps will help you to prepare the autoloader for shipment, remove the autoloader from a rack, and
package the autoloader.
To prepare the autoloader for shipment
1. Remove all cartridges from the unit.
2. Power off the autoloader through the front panel.
3. Remove the power, Ethernet, and SAS cables from the autoloader.
NOTE: Do not ship these items if you are returning the autoloader.