Dell PowerVault 124T - Manual (Page 23)

or through the RMU. The time zone setting is not lost when powered off.
NOTE: Whether the autoloader is connected to a time server or not, if you want to include time
changes for daylight savings time, you must change the time zone manually.
To set the system time:
1. Using the first drop-down list next to Time Zone, select the number of hours difference between
your local time and Greenwich Mean Time (GMT).
NOTE: For example, if you live in Colorado, the time difference is –6 hours in the summer and –
7 hours in the winter.
2. Below the Time Zone field, select the current Month from the drop-down list.
3. In the Day field, type the current day of the month.
4. In the Year field, type the current year.
5. In the Hour text box, type the current hour in 24-hour format.
6. In the Minute text box, type the current minute.
7. Click Submit to save the information.
Setting Network Options
When you originally installed the autoloader, you set the Ethernet configurations through the front LCD
panel (also see " IPv6 Addendum "). However, you can modify them through the RMU. The options include
Current Network Parameters, Set IP, and Set Network Configuration. To change the Ethernet
configurations:
To view the Current Network Parameters:
1. From any page, click the Configuration heading. The Configuration screen displays.
2. From the Configuration menu, click Networking.
The Current Network Parameters area displays the current IP address, MAC address, and the
speed setting for the Ethernet connection.
In the Set IP section, if a check mark appears in the box next to DHCP, the dynamic IP address option is
enabled. This means that with every reset of the system, the IP address may change depending on the
network administrator's settings.
To Set IP address:
1. Clear the check box to remove the check mark from the DHCP field, if applicable.
2. In the IP address fields, type the static IP address using the key to move from box to box.
3. If no check mark appears in the box next to DHCP, the static IP address option is enabled. To
change a static IP address, type in the new address in the IP address fields using the key to
move from box to box.
4. To change the IP address from a static address to a dynamic address, click the box next to DHCP.
To Set Network Configuration:
1. To change the values of the subnet mask, gateway, Simple Network Management Protocol (SNMP)
server, or the time server, type in the new address, using the key to move from box to box.
2. Click Submit.