Dell PowerVault 124T - Manual (Page 53)

CE Motor Translation Pin
Jammed Error
CF Motor Asynchronous Stop
Magazine Hardware Error Types
D0 Magazine Eject Failed
Ensure that the autoloader is resting on a solid flat surface, or
mounted level in a rack unit.
Remove and re-insert the magazine. Verify that the magazine
slides freely in and out of the magazine bay.
Verify that the magazine clicks and locks in place when fully
inserted.
Power cycle the autoloader and retry the operation.
If all previous steps fail, see Contacting Dell .
D1 Magazine Present Sensor
Bad
D2 Magazine Cam Position
Sensor Bad Ensure that the autoloader is resting on a solid flat surface, or
mounted level in a rack unit.
Remove and re-insert the magazine. Verify that the magazine
slides freely in and out of the magazine bay.
Verify that the magazine clicks and locks in place when fully
inserted.
Power cycle the autoloader and run the Magazine Test from the
Operator Control Panel.
If all previous steps fail, see Contacting Dell .
D3 Magazine Sensor 1 Bad
D4 Magazine Sensor 2 Bad
D5 Magazine Flag Missing Magazine errors may occur if the magazine sensor cannot detect
cartridge carrier flags during magazine rotation. This may be caused by
an issue with a cartridge carrier flag, a sensor problem, a physically
jammed magazine, or a sensor alignment issue caused by a mis-
inserted magazine.
Ensure that the autoloader is resting on a solid flat surface, or
mounted level in a rack unit.
Remove and inspect the magazines one at a time. Turn the white
thumbwheels on each magazine and ensure that the carriers
move freely at least one full rotation in each direction.
Verify that carrier flags are present on all slots and slot 1 has the
unique (longer) carrier flag.
Ensure that the sensors protruding from the picker into the
magazine bays are free of debris, and 'float' in and out freely
when pushed by hand.
Carefully re-insert the magazine straight into the magazine bay.
Be careful to avoid twisting or biasing the magazine up or down.
Power cycle the autoloader.
Run the Magazine Test from the operator control panel.
If all previous steps fail, see Contacting Dell .
D6 Magazine Flag Bad
D7 Slot Zero Not Found
D8 Multiple Slot Zero
Detected
D9 Magazine Step Tolerance
Error
DA Magazine Calibration Lost
DB Magazine Lost
DC Magazine Position Error
DD Magazine Slot Type
Invalid
DE Magazine Slot (Gross)
Position Error
DF Magazine Jammed Error
System Event Types
E8 Time Zone Update Event User updated the time zone setting. No action required.
E9 Time Update Event The system time was changed. No action required.