Dell PowerVault 124T - Manual (Page 4)

1 Power switch
2 Media door (mailslot)
3 Front panel LEDs
4 Front panel LCD screen
5 Function keys
6 Left magazine
7 Right magazine (or blank)
Back Panel Overview
1 SAS connector
2 Fan vent
3 Power connector
4 Ethernet connector
5 Power switch
NOTE: If the cover must be taken off, there are 26 screws and 6 rail bolts that need to be removed. The cover should be removed only by a qualified Dell Service
Provider.
Unpacking the Autoloader
Before you begin, clear a desk or table so that you can unpack the autoloader. You also need to select an open 2U computer rack location near the server that will host the
autoloader.
Caution: If the room in which you are working differs from the temperature in which the autoloader was shipped or stored by 15°C (30°F) or more, let the autoloader
acclimate to the surrounding environment for at least 24 hours before opening the shipping carton.
Unpack and inspect the autoloader for shipping damage by doing the following:
1. Clear a table or desk so that you have room to unpack the autoloader.
2. Inspect the shipping box for damage. If you notice any damage, report it to the shipping company immediately.
3. Open the shipping box and remove the accessories package. Set the accessories package aside for now.
4. Lift the autoloader and padding out of the box and place it on the work surface, top facing up. Do not set the autoloader on either end or sides.
5. Carefully remove the shipping padding from the front and back of the autoloader. Then remove the bag from the autoloader. Save the packing materials in case you
need to move or ship the autoloader in the future. Illustrations on the box flaps indicate proper placement of the packaging materials.
Caution: If your unit was ordered as a one-magazine autoloader, be sure to remove the plastic shipping insert from the magazine bay before connecting or operating
your autoloader. Insert either a magazine or a magazine blank into the bay. The autoloader will not function without both magazine bays equipped with either a
magazine or a magazine blank.
Identifying Product Components
Accessories