Dell PowerVault NX300 - Manual (Page 94)

94
Installing System Components
5 Install the expansion card:
a Holding the card by its edges, position the card so that the card-edge
connector aligns with the expansion-card connector on the expansion-
card riser.
b Insert the card-edge connector firmly into the expansion-card
connector until the card is fully seated.
c Close the expansion-card latch. See Figure 3-9.
Figure 3-9. Installing or Removing an Expansion Card
6 Connect any cables to the expansion card.
7 Close the system. See "Closing the System" on page 83.
8 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
1 expansion-card latch 2 expansion card
3 expansion-card riser
2
1
3
book.book Page 94 Thursday, August 13, 2009 7:27 AM