Dell PowerVault NX300 - Manual (Page 46)

46
About Your System
No boot device
available
Faulty or missing optical
drive subsystem, hard drive,
or hard drive subsystem, or
no bootable USB key
installed. Use a bootable USB key,
optical drive, or hard drive.
If the problem persists,
see "Troubleshooting an
Optical Drive" on page 157,
"Troubleshooting a USB
Device" on page 148,
"Troubleshooting an Internal
USB Key" on page 156, and
"Troubleshooting a Hard
Drive" on page 158.
See "Using the System Setup
Program and UEFI Boot
Manager" on page 57 for
information on setting the
order of boot devices.
No boot sector on
hard drive
Incorrect configuration
settings in System Setup
program, or no operating
system on hard drive. Check the hard drive
configuration settings in the
System Setup program.
See "Using the System Setup
Program and UEFI Boot
Manager" on page 57.
If necessary, install the
operating system on your
hard drive. See your
operating system
documentation.
No timer tick
interrupt
Faulty system board. See "Getting Help" on
page 177.
PCIe Training
Error: Expected
Link Width is x,
Actual Link Width
is y.
Faulty or improperly
installed PCIe card in the
specified slot. Reseat the PCIe card in the
specified slot number.
See "Troubleshooting
Expansion Cards" on
page 161. If the problem
persists, see "Getting Help"
on page 177.
Table 1-3. System Messages (continued)
Message Causes Corrective Actions
book.book Page 46 Thursday, August 13, 2009 7:27 AM