Dell PowerVault NX300 - Manual (Page 44)

44
About Your System
Invalid PCIe card
found in the
Internal_Storage
slot!
The system halted because
an invalid PCIe expansion
card is installed in the
dedicated storage controller
slot. Remove the PCIe expansion
card and install the
integrated storage controller
in the dedicated slot. See
"RAID Battery (Optional)"
on page 113.
Keyboard fuse has
failed
Overcurrent detected at the
keyboard connector. See "Getting Help" on
page 177.
Local keyboard
may not work
because all user
accessible USB
ports are
disabled.
If operating
locally, power
cycle the system
and enter system
setup program to
change settings.
The USB ports are disabled
in the system BIOS. Power down and restart the
system from the power
button, and then enter the
System Setup program to
enable the USB port(s).
See "Entering the System
Setup Program" on page 58.
Manufacturing
mode detected
System is in manufacturing
mode. Reboot to take the system
out of manufacturing mode.
Maximum rank
count exceeded.
The following
DIMM has been
disabled: x
Invalid memory
configuration. The system
will run but with the
specified memory module
disabled. Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines" on
page 115.
Memory
Initialization
Warning: Memory
size may be
reduced
Invalid memory
configuration. The system
will run but with less memory
than is physically available. Ensure that the memory
modules are installed in a
valid configuration.
See "General Memory
Module Installation
Guidelines" on page 115.
Table 1-3. System Messages (continued)
Message Causes Corrective Actions
book.book Page 44 Thursday, August 13, 2009 7:27 AM