Processors, Removing a processor – Dell PowerVault NX300 User Manual
Page 122
122
Installing System Components
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 82.
3 Remove the system board shroud. See "Removing the System Board
4 Locate the memory module sockets. See Figure 6-1.
5 Press down and out on the ejectors on each end of the socket until the
memory module pops out of the socket. See Figure 3-19.
Handle each memory module only on either card edge, making sure not to
touch the middle of the memory module.
6 Replace the system board shroud. See "Installing the System Board
7 Close the system. See "Closing the System" on page 83.
8 Reconnect the system and peripherals to their power sources, and turn
them on.
Processors
Removing a Processor
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Prior to upgrading your system, download the latest system BIOS version
from support.dell.com and follow the instructions included in the
compressed download file to install the update on your system.
2 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet. When disconnected from AC power,
press and hold the power button for 3 seconds to fully drain the system of
stored power prior to removing the cover.
NOTE:
It is recommended that you always use a static mat and static strap while
working on components in the interior of the system.
book.book Page 122 Thursday, August 13, 2009 7:27 AM