Dell PowerVault NX300 - Manual (Page 124)

124
Installing System Components
Figure 3-20. Installing and Removing the Heat Sink
CAUTION:
The processor is held in its socket under strong pressure. Be aware
that the release lever can spring up suddenly if not firmly grasped.
9 Position your thumb firmly over the processor socket-release lever and
release the lever from the locked position by pushing down and pulling out
from under the tab. Rotate the lever 90 degrees upward until the processor
is released from the socket. See Figure 3-21.
10 Use the tab on the processor shield to rotate shield upward and out of the
way. See Figure 3-21.
1 heat-sink retention screws (4) 2 heat sink
1
2
book.book Page 124 Thursday, August 13, 2009 7:27 AM