Dell OptiPlex GX1 User Manual

Page 105

Inside Your Computer: Dell OptiPlex GX1 Small-Form-Factor System User's Guide

file:///C|/infodev/2013/eDoc/OpGX1/UG/inside.htm[2/21/2013 11:47:19 AM]

cage

3 Tab

4 Hook

4. Slide the expansion-card cage out of the chassis.

5. Lift the expansion-card cage up and away from the chassis.

To replace the expansion-card cage in the small-form-factor chassis, perform the following steps:

1. With the securing lever in the upright position, align the slots in the left side of the expansion-card cage

with the tabs on the back and bottom of the chassis (see

). Slide the expansion-card cage into

place.

2. Rotate the securing lever downward until it is flush with the top side of the chassis. Make sure that the

riser board is fully seated in the RISER connector on the system board.

3. Reconnect any cables you removed in

of the previous procedure.

, and reconnect your computer and peripherals to their electrical outlets

and turn them on.

NOTE: If Enabled, the

option will cause the following message to be displayed

at the next system start-up:

ALERT! Cover was previously removed.