Dell OptiPlex GX1 - Manual (Page 104)

Inside Your Computer: Dell OptiPlex GX1 Small-Form-Factor System User's Guide
file:///C|/infodev/2013/eDoc/OpGX1/UG/inside.htm[2/21/2013 11:47:19 AM]
KYBD Keyboard connector
LINE-IN Audio line-in jack
LINE-OUT Audio line-out jack
MIC Microphone jack
MONITOR Video connector
MOUSE Mouse connector
P1 Wakeup On LAN power connector (on riser board)
PANEL Control panel connector
PARALLEL Parallel port connector, sometimes referred to as LPT1
PCIn PCI expansion-card connector (on riser board)
POWER_1 Main power input connector
POWER_2 3.3-V power input connector
RISER Riser board connector
SERIALn Serial port connectors
SLOT1 Microprocessor connector
TAPI Telephony connector
USB USB connector
VIDEO_UPGRADE Video-memory upgrade socket
Removing and Replacing the Expansion-Card Cage
To remove the expansion-card cage from the small-form-factor chassis, perform the following steps.
CAUTION: Before you remove the computer cover, see " Safety First—For You and Your
Computer ."
1. Remove the computer cover .
2. Check any cables connected to expansion cards through the back-panel openings. Disconnect any
cables that will not reach to where the cage must be placed upon removal from the chassis.
3. Locate the securing lever (see Figure 5). Rotate the lever upward until it stops in an upright position.
Figure 5. Removing the Expansion-Card Cage From the Small-Form-Factor Chassis
1 Securing lever
2 Expansion-card