Dell OptiPlex GX1p - Manual (Page 30)

ERROR: Failed to activate device,
CSN=Card Select Number. A Plug and Play expansion card
could not be activated. Use the following procedure:
1. Exit the ICU and turn off your system.
2. Remove the Plug and Play expansion card
that could not be activated.
Follow steps 2 through 6 of "
Removing an
Expansion Card " and then return to this
procedure.
3. Reinstall the Plug and Play expansion card.
Follow steps 5 through 10 of "
Installing an
Expansion Card " and then return to this
procedure.
If you still receive the error message, contact the
manufacturer of the Plug and Play expansion card for
assistance.
WARNING: Could not configure Plug
and Play Card Name.
WARNING: Could not configure PCI
device, ID=DeviceID.
Failed to configure Number of Total
Count Plug and Play ISA devices.
Use your system's configuration
utility to resolve conflicts. Press
any key to continue.
The card(s) mentioned are not
fully configured due to resource
conflicts. If you have documentation that lists the allowable
resource values for your Plug and Play or PCI expansion
card, you can use the following procedure to locate and
resolve the resource conflict.
NOTE: If you do not have documentation listing the
allowable resource values, see the corrective action for
these messages on the following page.
1. Start the ICU.
Any Plug and Play or PCI expansion cards that
could not be configured should be marked
config err
on the list of cards in the ICU
window.
2. Select the System Resources option from the
View menu.
The System Resource Usage dialog box displays
all resources currently used by the system.
3. Select one of the resources used by your
Plug and Play or PCI expansion card, and
click Used By Card.
The Card Resources Usage dialog box identifies
which device is using the resource.
4. Repeat step 3 until you have identified all
conflicting resources and the cards that use
them.
5. Modify the cards, as needed, to free the
resources required by the unconfigured Plug
and Play or PCI expansion card.
See "
Modifying a Card " for instructions.
WARNING: Could not configure Plug
and Play Card Name.
WARNING: Could not configure PCI
device, ID=DeviceID.
Failed to configure Number of Total
Count Plug and Play ISA devices.
Use your system's configuration
utility to resolve conflicts. Press
any key to continue.
The card(s) mentioned are not
fully configured due to resource
conflicts. If you do not know the allowable resource values for your
Plug and Play or PCI expansion card, use the following
procedure to locate and resolve the resource conflict:
1. Remove all card configurations from the ICU.
See "
Removing a Card " for instructions.
2. Reboot your system.
The ICU should automatically configure your Plug
and Play or PCI expansion card.
3. Add the ISA expansion cards back into the
ICU, resolving any resource conflicts as they
arise.