Intermediate driver (virtual adapter/team) – Dell Broadcom NetXtreme Family of Adapters User Manual
Page 96

Broadcom Gigabit Ethernet Teaming Services: Broadcom NetXtreme BCM57XX User Guide
file:///C|/Users/Nalina_N_S/Documents/NetXtreme/English/teamsvcs.htm[9/5/2014 3:32:13 PM]
network cable is properly
connected.
connection with its link partner.
that the link partner (for example, switch or hub)
is working correctly.
5
The network link is up.
The adapter has established a
link.
Informational message only. No action is required.
6
Network controller
configured for 10Mb half-
duplex link.
The adapter has been manually
configured for the selected line
speed and duplex settings.
Informational message only. No action is required.
7
Network controller
configured for 10Mb full-
duplex link.
The adapter has been manually
configured for the selected line
speed and duplex settings.
Informational message only. No action is required.
8
Network controller
configured for 100Mb
half-duplex link.
The adapter has been manually
configured for the selected line
speed and duplex settings.
Informational message only. No action is required.
9
Network controller
configured for 100Mb full-
duplex link.
The adapter has been manually
configured for the selected line
speed and duplex settings.
Informational message only. No action is required.
10
Network controller
configured for 1Gb half-
duplex link.
The adapter has been manually
configured for the selected line
speed and duplex settings.
Informational message only. No action is required.
11
Network controller
configured for 1Gb full-
duplex link.
The adapter has been manually
configured for the selected line
speed and duplex settings.
Informational message only. No action is required.
12
Medium not supported.
The operating system does not
support the IEEE 802.3 medium.
Reboot the operating system, run a virus check,
run a disk check (chkdsk), and reinstall the
operating system.
13
Unable to register the
interrupt service routine.
The device driver cannot install
the interrupt handler.
Reboot the operating system; remove other device
drivers that may be sharing the same IRQ.
14
Unable to map IO space.
The device driver cannot allocate
memory-mapped I/O to access
driver registers.
Remove other adapters from the system, reduce
the amount of physical memory installed, and
replace the adapter.
15
Driver initialized
successfully.
The driver has successfully
loaded.
Informational message only. No action is required.
16
NDIS is resetting the
miniport driver.
The NDIS layer has detected a
problem sending/receiving packets
and is resetting the driver to
resolve the problem.
Run Broadcom Advanced Control Suite diagnostics;
check that the network cable is good.
17
Unknown PHY detected.
Using a default PHY
initialization routine.
The driver could not read the PHY
ID.
Replace the adapter.
18
This driver does not
support this device.
Upgrade to the latest
driver.
The driver does not recognize the
installed adapter.
Upgrade to a driver version that supports this
adapter.
19
Driver initialization failed. Unspecified failure during driver
initialization.
Reinstall the driver, update to a newer driver, run
Broadcom Advanced Control Suite diagnostics, or
replace the adapter.
Intermediate Driver (Virtual Adapter/Team)
lists the event log messages supported by the intermediate driver, explains the cause for the message, and provides
the recommended action.
Table 10. Intermediate Driver Event Log Messages
System
Event
Message
Number
Message
Cause
Corrective Action
1
Unable to register with NDIS.
The driver cannot register
with the NDIS interface.
Unload other NDIS drivers.
2
Unable to instantiate the
The driver cannot create a
Reboot the operating system.