Iscsi crash dump – Dell Broadcom NetXtreme Family of Adapters User Manual
Page 34
iSCSI Protocol: Broadcom NetXtreme BCM57XX User Guide
file:///C|/Users/Nalina_N_S/Documents/NetXtreme/English/iscsi.htm[9/5/2014 3:32:08 PM]
Problem: When switching iSCSI boot from the Microsoft standard path to Broadcom iSCSI offload, the booting fails to
complete.
Solution: Install or upgrade the Broadcom Virtual Bus Device (VBD) driver to 5.0.x, along with the OIS driver, prior to
switching the iSCSI boot path.
Problem: The iSCSI configuration utility will not run.
Solution: Ensure that the iSCSI Boot firmware is installed in the NVRAM.
Problem: A system blue screen occurs when installing the Broadcom drivers through Windows Plug-and-Play (PnP).
Solution: Install the drivers through the Setup installer.
Problem: For static IP configuration when switching from Layer 2 iSCSI boot to Broadcom iSCSI HBA, then you will receive
an IP address conflict.
Solution: Change the IP address of the network property in the OS.
Problem: After configuring the iSCSI boot LUN to 255, a system blue screen appears when performing iSCSI boot.
Solution: Although Broadcom's iSCSI solution supports a LUN range from 0 to 255, the Microsoft iSCSI software initiator
does not support a LUN of 255. Configure a LUN value from 0 to 254.
Problem: NDIS miniports with Code 31 yellow-bang after L2 iSCSI boot install.
Solution: Run the T7.4 installer.
Problem: Unable to update inbox driver if a non-inbox hardware ID present.
Solution: Create a custom slipstream DVD image with supported drivers present on the install media.
Problem: In Windows Server 2012, toggling between iSCSI HBA offload mode and iSCSI software initiator boot can leave the
machine in a state where the HBA offload miniport bxois will not load.
Solution: Manually edit [HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\bxois\StartOverride] from 3 to 0.
Modify the registry key before toggling back from NDIS to HBA path in CCM.
NOTE: Microsoft recommends against this method. Toggling the boot path from NDIS to HBA or vice versa
after installation is completed is not recommended.
Problem: The Xen hypervisor will not start when booting from an iSCSI image created with the RHEL 5.4 Xen kernel.
Solution: This is a known third-party issue. To work around this issue, disable the Xen hypervisor's EDD feature by editing
the grub.conf file in the boot/grub folder to add the edd=off switch to the end of the kernel line. For example,
kernel /xen.gz edd=off
.
Problem: Unable to connect to an EqualLogic target using Windows Server 2008 and higher.
Solution: Add an exception to your firewall to allow ICMP echo requests.
Problem: Installing Windows onto an iSCSI target via iSCSI boot fails when connecting to a 1 Gbps switch port.
Solution: This is a limitation relating to adapters that use SFP+ as the physical connection. SFP+ defaults to 10 Gbps
operation and does not support autonegotiation.
iSCSI Crash Dump
If you will use the Broadcom iSCSI Crash Dump utility, it is important to follow the installation procedure to install the iSCSI
Crash Dump driver. See