Dell PowerEdge T300 - Manual (Page 39)

About Your System
39
Warning! Detected
missing RAID
hardware for the
embedded RAID
subsystem.
RAID key or RAID DIMM
missing when system is in
RAID mode. Information only.
Warning! Detected
mode change from
SCSI to RAID on
channel x of the
embedded RAID
subsystem.
The embedded RAID
subsystem configuration
has changed in System
Setup. See "Using the System Setup
Program" on page 42.
Warning! Detected
mode change from
RAID to SCSI on
channel n of the
embedded RAID
subsystem.
The embedded RAID
subsystem configuration
has changed in System
Setup. See "Using the System Setup
Program" on page 42.
Warning! Embedded
RAID firmware is
not present.
The embedded RAID
firmware does not
respond. See "Using the System Setup
Program" on page 42.
Warning! Embedded
RAID error!
The embedded RAID
firmware responds with an
error. See "Using the System Setup
Program" on page 42.
Warning: The
installed memory
configuration is
not optimal. For
more information on
valid memory
configurations,
please see the
system
documentation on
support.dell.com
Invalid memory
configuration. The system
will run but at a reduced
functionality. Ensure that the memory
modules are installed in a
valid configuration (see
"Memory Module
Installation Guidelines" on
page 111). If the problem
persists, see
"Troubleshooting System
Memory" on page 146.
Table 1-6. System Messages (continued)
Message Causes Corrective Actions
book.book Page 39 Sunday, June 21, 2009 10:04 AM