Dell PowerEdge T300 - Manual (Page 33)

About Your System
33
Fatal Error caused
a system reset:
Please check the
system event log
for details
A fatal system error
occurred and caused the
system to reboot. Check the SEL for
information that was logged
during the error. See the
applicable troubleshooting
section in "Troubleshooting
Your System" on page 133 for
any faulty components
specified in the SEL.
Gate A20 failure Faulty keyboard
controller; faulty system
board. See "Getting Help" on
page 175.
General failure The operating system is
unable to carry out the
command. This message is usually
followed by specific
information. Note the
information, and take the
appropriate action to resolve
the problem.
Keyboard Controller
failure
Faulty keyboard
controller; faulty system
board See "Getting Help" on
page 175.
Keyboard data line
failure
Keyboard stuck key
failure
Keyboard cable connector
is loose or improperly
connected, defective
keyboard, or defective
keyboard/mouse controller Check the keyboard
connection to the system. If
the problem persists, try
another keyboard.
Manufacturing mode
detected
System is in
manufacturing mode. Reboot to take the system
out of manufacturing mode.
Table 1-6. System Messages (continued)
Message Causes Corrective Actions
book.book Page 33 Sunday, June 21, 2009 10:04 AM