Media card reader – Dell OptiPlex 755 User Manual
Page 62
4.
Attach the power and data cables to the floppy drive.
5.
Align the shoulder screws with the screw guides, and slide the drive into the bay until it clicks into place.
6.
Replace the optical drive (see
).
7.
Check all cable connections, and fold cables out of the way to provide airflow for the fan and cooling vents.
8.
Replace the computer cover (see
Replacing the Computer Cover
).
9.
Enter system setup and set the Diskette Drive option to enable your new floppy drive (see
System Setup
).
10.
Verify that your computer works correctly by running the Dell Diagnostics (see
Dell Diagnostics
).
Media Card Reader
Removing a Media Card Reader
1.
Follow the procedures in
Before You Begin
.
2.
Remove the computer cover (see
Removing the Computer Cover
).
3.
Remove the optical drive (if one exists) and carefully set it aside (see
).
4.
Pull up on the drive-release latch and slide the media card reader to the back of the computer. Then, lift up to remove the drive from the computer.
1 power cable
2 slot verification number
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before removing the computer cover.
NOTE:
If you will be operating your computer without an optical drive or a 3.5-inch drive installed, the appropriate drive bay insert must be installed in
place of the drive. Contact Dell if you need a drive bay insert.
NOTE:
Since the following steps do not require the complete removal of the optical drive, it is not necessary to disconnect the cables connecting
the optical drive.
NOTICE:
Do not pull the drive out of the computer by the drive cables. Doing so may cause damage to cables and the cable connectors.