Module bay – Dell OptiPlex 755 User Manual
Page 229
Back to Contents Page
User's Guide
Module Bay
You can install a Dell™ removable device such as a floppy drive, optical drive, or second hard drive in the module bay. You can also install an airbay (filler blank)
in the bay if you do not plan to install a drive.
Your Dell computer ships with either an optical drive or an airbay (filler blank) installed in the module bay. The airbay is held in the module bay with a security
screw only. You can secure a optical drive in the module bay using two methods:
l
Locking switch (accessed by removing the computer cover)
l
Security screw (packaged separately)
Securing a Device in the Module Bay
for more information about securing a device in your computer.
Installing a Device When Your Computer Is Turned Off
To install a device in the module bay:
1.
Remove any installed device from the bay. If the module bay contains an airbay, remove the security screw and pull the airbay out of the module bay
and skip to
.
2.
If the module bay contains a device that is locked with the locking switch, remove the cover (see
Removing the Computer Cover
) and lift the module
locking switch to the unlocked position. If a security screw is also used, remove the screw.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE:
To prevent damage to devices, place them in a safe, dry place when they are not installed in the computer. Avoid pressing down on them or
placing heavy objects on top of them.
1 bottom of computer
2 security screw