ADS Environmental Services RainAlert II QR 775008 A2 - Manual (Page 81)

5-14 ADS RainAlert II Manual
3. Select or enter the communication parameters as necessary:
 Modem Name Select the modem you want to use during
modem communication from the drop-down list. This list
should include all available modems on your computer.
 Modem Port Select the proper port for modem
communication from this drop-down list. This list should
include all available ports on your computer.
 Serial Port Select the proper port for serial
communication from this drop-down list. This list should
include all available ports on your computer.
 DMI Port (This parameter does not apply to the
RainAlert II monitor)
 Timeout Enter the number of seconds you want your
local computer to wait for a response from the monitor
once communication has been initiated.
 Retries Enter the number of times you want your local
PC to request data from the monitor following failed
attempts while the monitor is still on line.
 Low Temperature (This parameter does not apply to
the RainAlert II monitor)
 High Temperature (This parameter does not apply to
the RainAlert II monitor)
 Log Communications Select this checkbox to record
all communication activities with the monitor.
 Status On Connect Select this checkbox to view
details of the current state of the monitor when monitor
communications are established.
 Low Battery 1502, 1506, 3500, 4000 (These
parameters do not apply to the RainAlert II monitor)
 Low Modem Battery TCP/IP (This parameter does not
apply to the RainAlert II monitor)
 Low Signal Strength TCP/IP Enter the signal strength
(in dBm) below which you want Profile to provide