ADS Environmental Services RainAlert II QR 775008 A2 - Manual (Page 35)

3-14 ADS RainAlert II Manual
Installing the RainAlert II
The RainAlert II monitor is designed for indoor or outdoor
installation and can mount directly to a wall or sit on an optional
base plate. A sun shield also is available for limited protection from
the elements and/or when installing the monitor and tipping bucket
together.
The following procedures for monitor installation apply to most
sites. However, some sites may require the installer to implement
slight modifications to the standard installation technique.
Before installing the monitor at the site, activate the monitor to
verify that the monitor is configured correctly for the application
and that the battery pack (or external power) is operating at an
adequate voltage. Refer to Chapter 5, Configuration and
Activation, for more information. ADS recommends making any
necessary changes to the configuration before installing the unit.
Refer to Chapter 6, Maintenance and Troubleshooting, for
information on replacing the battery pack, if necessary.
Warning: Using a battery-powered, wireless monitor
without connecting an antenna will significantly decrease
the life of the battery pack.
Note: The base plate used when installing the tipping
bucket, monitor, and sun shield is not designed to be
attached or secured to the surface on which it is set.
Therefore, select a suitable location to place the plate and
the corresponding hardware so they will not be adversely
affected by existing or potential conditions inherent to the
location. In addition, installers and technicians must
comply with all federal, state, and municipal safety
regulations. ADS is not responsible for any injuries,
damages, claims, or liability resulting directly or indirectly
from the use of this installation guide or the installation of
any ADS equipment.