ADS Environmental Services RainAlert II QR 775008 A2 - Manual (Page 137)

In-6 ADS RainAlert II Manual
configuring the power savings
parameters, 5-19
editing the notification device, 5-9
editing the rain device, 5-8
editing the RSSI device, 5-11
launching software, 5-2
running diagnostics on rain
device, 5-24
selecting and editing devices, 5-6
setting communication parameters,
5-12
upgrading the monitor firmware,
5-35
viewing logs, 5-38
R
rain device
editing, 5-8
running diagnostics, 5-24
rain measurement
calibrating the tipping bucket,
3-11
installing the tipping bucket, 3-7
tipping bucket, 2-9
remote communication
setting up land line
communication, 4-14
setting up wireless
communication, 4-2
replacing the battery pack, 6-5
RSSI device
editing, 5-11
running diagnostics, 5-24
S
setting communication parameters,
5-12
signal strength, 5-12
editing the RSSI device, 5-11
SIM (Subscriber Identity Module),
4-2
SIM card installation, 4-9
site investigation, 3-3
slim antenna
installation, 4-4
specifications, A-1
board, A-3
external wireless antennas, B-1
lightning protection module, A-5
monitor, A-1
tipping bucket, A-4
static IP address, 4-2
Subscriber Identity Module (SIM),
4-2
sun shield
mounting the tipping bucket, 3-8
part number, B-1
T
TCP/IP, 5-12
telephone cable
preparing for connection, 4-17
running between monitor and
service locations, 4-15
wiring lightning protection
module to network interface
box, 4-23
wiring to lightning protection
module, 4-21
wiring to monitor, 4-19
telephone service, 4-14
installation, 4-14
connecting ground wires, 4-23
mounting lightning protection
module, 4-16
preparing the telephone cable,
4-17
running cable between the
monitor and service
locations, 4-15
verifying grounding, 4-16
wiring lightning protection
module to network interface
box, 4-23