ADS Environmental Services RainAlert II QR 775008 A2 - Manual (Page 50)

Communication 4-9
Installing the SIM Card
RainAlert II monitors require a standard SIM card for wireless
communication. This card must be installed in the monitor before
communication can occur. The monitor uses SIM cards provisioned
by AT&T (ADS p/n 507181) for public static IP address operation.
Please contact ADS for specific information on procuring SIM
cards for use in the specific geographic area.
Install the SIM card in the monitor in the following way:
1. Record the number from the SIM card (i.e., the IP address) on
the site report. This address is required for reconciling billing
and setting up the LIF in the Profile software. This IP address
is printed directly on the SIM card or on a label affixed to the
card.
Sample SIM card
2. Undo the latches to the door of the monitor enclosure, and open
the door.
Note: Opening the door to the enclosure and accessing
the printed circuit board increases the risk of damaging or
introducing debris or moisture to the board. Make every
effort to prevent water, dirt, and debris from contacting the
monitor’s printed circuit board when opening or working
within the enclosure.
3. Disconnect the battery pack cable from the circuit board power
cable.