ADS Environmental Services RainAlert II QR 775008 A2 - Manual (Page 136)

In-5
wiring telephone cable to
lightning protection module,
4-21
wiring telephone cable to
monitor, 4-19
installing wireless communication,
4-2
maintenance, 6-2
opening enclosure, 4-5, 6-6
part numbers, B-1
power, 2-7
replacing battery pack, 6-5
setting communication parameters,
5-12
setting power saving parameters,
5-19
SIM card installation, 4-9
specifications, A-1
tipping bucket, 2-9
troubleshooting, 6-12
upgrading the firmware, 5-35
viewing diagnostic logs, 5-38
voltage regulator, 2-5
monitor configuration, 5-2
creating a monitor location, 5-4
editing devices, 5-6
editing the notification device, 5-9
editing the rain device, 5-8
editing the RSSI device, 5-11
selecting devices, 5-6
mounting hardware
part numbers, B-1
mounting monitor on base plate, 3-16
mounting monitor to a wall, 3-15
mounting tipping bucket to base
plate, 3-8
mounting tipping bucket to sun
shield, 3-8
N
network interface box
connecting wires from lightning
protection module, 4-23
inspection, 6-8
notification device
editing, 5-9
O
on-site communication
using the direct connection cable,
4-26
P
part numbers
base plate, B-1
battery pack, B-1
board, B-1
cables, B-1
monitor, B-1
mounting hardware, B-1
sun shield, B-1
tipping bucket, B-1
port selection, 5-12
power, 2-7
battery pack replacement, 6-5
checking battery voltage, 6-4
voltage regulator, 2-5
printed circuit board, 2-4
processor, 2-4
Profile
activating the monitor, 5-16
collecting data from the monitor,
5-30