Great Plains YP1625 Operator Manual - Manual (Page 81)

7/12/2005 401-182M
79 Veris Drive Operating Instructions
Figure 86
Figure 88
Figure 87
Refer to Figure 86
1. Only after you have verified the drive area is
clear, press the up arrow key to initiate cali-
bration mode. If drive area isn’t clear, press
Down arrow key to exit calibration mode.
Refer to Figure 87
2. Continuing to verify that the drive area is
clear, press the Engage key to start drive ro-
tation. Pressing Function key will exit calibra-
tion mode.
Refer to Figure 88
3. While the drive is rotating, the display window
shows the time remaining and the “Out” rate.
CONTINUE TO MONITOR DRIVE AREA
DURING DRIVE ROTATION. PRESS THE
ENGAGE KEY (OR OFF KEY) TO STOP
DRIVE DURING CALIBRATION
22724
22783
22725