Great Plains YP1625 Operator Manual - Manual (Page 80)

1625
401-182M 7/12/2005
78
Figure 83
Figure 84
Figure 85
Refer to Figure 83
1. The cab console is informing you the length of
time that the drive will be operating, in order to
meter the amount of seed you have request-
ed, at the calibration number, drill width, and
number of rows you have selected. Press
Function key to advance to next window.
Refer to Figure 84
2. If the screen If the screen reads TIME TOO
LOW, or TIME TOO HIGH, you will need to
change the amount of seed that you will count
or measure. For calibration accuracy, the
Controller firmware will not allow you to cali-
brate at settings that would result in the drive
rotating for less than 4 seconds, or more that
255 seconds. Press Function key to advance
to next window.
Refer to Figure 85
!
WARNING
The drive is about to operate, meaning there is a dan-
ger of entanglement if anyone is in the drive area. Be
sure to verify that no one is near the drive area before
advancing to the next step.
22782
22781
22723