Great Plains YP1625 Operator Manual - Manual (Page 17)

7/12/2005 401-182M
15 Preparation and Setup
Refer to Figure 3
8. Remove the lower pin holding the parking
stand. Swing the parking stand back and up
until it is above the rear hole. Place the hold-
ing pin in the rear hole and allow the parking
stand to rest on it. This will be the transport
position for the parking stand.
9. Adjust the top link of 3-point long enough so
the ball swivel does not bottom out when fully
raised.
10. Secure hoses so they do not get caught in ball
swivel. Failure to do so could cause hose to
be crushed requiring hose replacement.
Bleeding Hydraulics
Bleeding Lift Hydraulics
Normally the lift hydraulics are bled at the factory
before shipping and bleeding should not be re-
quired other than to raise fully and hold lever on
for one minute or until all cylinders extend fully.
Bleeding Fold Cylinder Hydraulics
Normally the fold hydraulics are bled at the factory
before shipping and bleeding should not be re-
quired other than to fold fully and hold lever on for
one minute or until all cylinders reach the end of
their stroke.
Important: Do not fold or unfold without first
raising planter completely.
21925
Rear Hole
Lower Hole
Figure 3
Storing Parking Stand