Great Plains YP1625 Operator Manual - Manual (Page 21)

7/12/2005 401-182M
19 Preparation and Setup
Wing Alignment
To check and adjust wing alignment:
1. Unfold planter, see “Unfolding the Planter,”
page 22, and place a block ahead of each
wing gauge wheel. Pull planter forward
against blocks to rock frames back.
Refer to Figure 7
2. Check for proper alignment by running a
string line across back of planter toward outer
ends of wings. For proper alignment, outside
ends of wings (dimension A) should be 0-to-
1/4” ahead of inside ends (dimension B).
3. To adjust wing alignment, shorten or lengthen
eye bolts to change the length of the wing pull
bar. Adjust eye bolts (1) in or out until dimen-
sion A is 0 to 1/4” greater than dimension B.
Figure 7
Box Alignment
A B A B
1 1
Note: Angle of wings is exagger-
ated for ease of clarification.