Nforce™ led lightbar – SoundOff Signal nFORCE LED User Manual
Page 12
IMPORTANT INFORMATION:
Warning devices are strictly regulated and governed by Federal, State and Municipal ordinances. These devices shall be used ONLY on approved vehicles. It is the sole responsibility of the user of these devices to ensure compliance.
To review our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product, visit our website at
www.soundoffsignal.com/sales-support.
If you have questions regarding this product, contact
Technical Services, Monday - Friday, 8 a.m. to 5 p.m. at 1.800338.7337 (press #4 to skip the automated message).
Questions or comments that do not require immediate attention may be emailed to
SUPERIOR CUSTOMER RELATIONSHIPS. SMARTLY DESIGNED LIGHTING & ELECTRONIC SOLUTIONS.
nFORCE™ LED Lightbar
nForce Lightbar 05.14
Driver Module Replacement:
a. Verify power has been removed from lightbar before attempting service
b. Remove top cover
c. Unplug 3 pin power/data connector and LED module connectors from driver module assembly, noting location.
d. Remove driver module
e. Snap new driver module assembly into housing
f. Plug 3 pin power/data connector and LED module connectors into driver module assembly
g. Set DIP switch according to lightbar length and driver module location as shown below:
h. Apply power to lightbar and verify proper operation.
i. Set Switch #2 on Breakout Box to Down position then to Up position to store configuration into new driver module
j. Verify DIP switch settings if lightbar does not function properly, and repeat step ‘i’ if DIP switch setting is changed
*Power Distribution Assembly Location
*
*
*
*
*
*
12.