SoundOff Signal Taurus-Ghost Compass Light - Manual

1.800.338.7337 / www.soundoffsignal.com
ECPGHKF1B(xx) 11.12
! WARNING
This product contains high intensity LED devices. To
prevent eye damage, DO NOT stare into the light
beam at close range.
COMPASS FENDER LIGHT
ECPGHKF1B(xx) - FORD TAURUS
OPERATION:
1 Make secure connections as shown in
Wire Hook-Up Table below.
2 To sync light and make pattern selections
see reverse side.
WIRE HOOK-UP TABLE
WIRE COLOR: CONNECT TO:
RED +10-16Vdc
BLACK Ground (-)
WHITE ID/Pattern Select
IMPORTANT INFORMATION:
Warning devices are strictly regulated and governed by Federal, State and Municipal ordinances. These devices shall be used ONLY on approved vehicles. It is the sole responsibility of the user of these devices to ensure compliance.
To review our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product, visit our website at www.soundoffsignal.com/sales-support.
If you have questions regarding this product, contact Technical Services, Monday - Friday, 8 a.m. to 5 p.m. at 1.800338.7337 (press #4 to skip the automated message).
Questions or comments that do not require immediate attention may be emailed to [email protected].
SUPERIOR CUSTOMER RELATIONSHIPS. SMARTLY DESIGNED LIGHTING & ELECTRONIC SOLUTIONS.
INSTALLATION:
1. Remove the vent panel from the vehicle
per manufacturers instructions and install
the supplied clip nut onto the fender of the
vehicle. Figure 4.
2. Slide the Ghost Light Assembly into
the Trim Panel making sure the label is
facing down. Figure 1.
3. Run the Ghost Light cable through the
wire hole in the mounting bracket as
shown in figure 1.
4. Install the Mounting Bracket on the back of
the Ghost Light and the Trim Panel part
as shown. Figure 1. Use the 2 supplied #6
and #10 Torx Screws to attach the Mount-
ing Bracket to the Trim Panel. Tighten Snug.
Figure 1.
5. Run the cable assembly into the fender and
install to the power source. See page 2.
6. Snap the Compass Fender Light assembly
to the fender opening.
7. Secure the assembly with the supplied #8
Phillips screw.
- Fender Light pre-assembly -
Fig. 1
Mounting
Bracket
Trim Panel
UP
Ghost
Light Assembly
#10-16 Torx
Screws 2x
#6 Torx
Screws 2x
Wire
hole
- View from inside of fender-
All 5 mounting clips must rest on
inside edge of body opening.
Press firmly to ensure all 5 clips
are engaged.
Fig. 3
Fig. 2
-View from outside of fender-
Fig. 4
INSTALL
CLIP NUT