beautypg.com

SoundOff Signal UltraLITE Exterior Warning Bar 12 Module User Manual

12 module exterior bar, Warning

background image

WARNING

: Warning devices are strictly

regulated and governed by Federal, State and
Municipal ordinances. These devices shall be
used ONLY on approved vehicles. It is the sole
responsibility of the user of these devices to
ensure compliance.

!

WARNING

This product contains high intensity LED devices.

To prevent eye damage, DO NOT stare into light

beam at close range.

MOUNTING INSTRUCTIONS

Before starting the installation make certain
you have the correct bracket for your
application. A universal bracket is supplied.
The product is also designed for surface
mounting. Drill holes where required in the
mounting surface. The bolts provided can
slide back and forth in the bar’s rear
channel to align with the mounting holes.

Install the UltraLITE by following the
assembly instructions provided with the
brackets and check for security.

Important: DO NOT over tighten mounting
screws or nuts. This could cause
permanent damage to the light or bracket.
Use appropriate hardware for mounting.

Universal bracket shown is supplied but
mounting screws are customer supplied.

PATTERN SELECTION

Because of the variety of configuring
options see separate sheets for detailed
instructions

Input Voltage (+Vdc): EL3D12AØØ(x)

10-16Vdc

EL3D12AØØ(x)-24

10-30Vdc

Current: 6

Amps

Maximum

Wire Color Connect to:

Blue

Input 1 / Left Input

Green

Input 2 / Right Input

Brown

Input 3 / Warning Input

Red

+Vdc

Black Ground

(-)

White Pattern

Select

WIRE HOOK-UP TABLE

EL3D12A(xxx) 3.09

BLACK

RED

WHITE

12 MODULE UltraLITE

BROWN

GREEN

BLUE

+Vdc

10A FUSE

12 MODULE EXTERIOR BAR

ASSEMBLY

INSTRUCTIONS

12v: EL3D12AØØ(x)

10-30v: EL3D12AØØ(x)-24

10-30v w/ 50’ CABLE: EL3D12A(x)L(x)-24

UNIVERSAL BRACKET

SUPPLIED BAR
MOUNTING HARDWARE