beautypg.com

SoundOff Signal LED3 Surface Mount (10-16v) User Manual

Single exterior led3 warning light, Warning, Assembly instructions el3sn(x)

background image

2x Supplied
#6 x 3/4” Sheet metal Screws

Supplied Gasket

EL3SN(x) 4.10

SINGLE EXTERIOR

LED3 WARNING LIGHT

ASSEMBLY INSTRUCTIONS

EL3SN(x)

!

WARNING

This product contains high intensity LED

devices. To prevent eye damage, DO NOT

stare into light beam at close range.

MOUNTING

Important: DO NOT over tighten
mounting screws or nuts. This could
cause permanent damage to the light.
1. Locate flat mounting location for the

LED3 Light.

2. When the position of LED3 is

determined use paper template on
next page to drill hole locations. Screw
mounting holes should be drilled using
a 3/32” drill bit. Wire entry holes
should be drilled using a 1/4” drill bit.

3. Make electrical connections.

4. Using supplied #6 x 3/4” screws, fasten

LED3 to mounting surface. Be sure
not to overtighten screws as this will
cause hole in mounting surface to strip
out. Be sure that supplied gasket is
mounted between mounting surface
and LED3.

NOTE: The LED3 is a factory sealed unit that

CANNOT be serviced in the field. Any attempt
to gain access to the LED3 unit will most likely
cause permanent damage and void its
warranty.

IMPORTANT: DO NOT connect this device

to a strobe power supply.

OPERATING INSTRUCTIONS

See Configuration Instructions.

The single LED3 comes equipped with an

internal flasher with 33 user selectable
patterns that can be synchronized either
alternating or simultaneous with up to three
other lights. It can also be put into slave mode
and driven through an external flasher.

1. Connect the LED3 BLACK wire to a good,

convenient ground.

2. Connect the LED3 RED wire to one side of a

user supplied on/off switch. Connect the other
side of the switch, through a 5Amp fuse, to a
source of +10-16Vdc.

2.5"W x 1.375"H x 1.25"D

33

10-16Vdc
0.5 Amps

Yes

-40º to +65º C

TECHNICAL SPECIFICATIONS

Overall Dimensions:

Flash Patterns:

Input Voltage:

Current Consumption:

Light Sync Technology:

Operating Temperature:

WARNING

: Warning devices are strictly

regulated and governed by Federal, State
and Municipal ordinances. These devices
shall be used ONLY on approved vehicles.
It is the sole responsibility of the user of
these devices to ensure compliance.

Drill Template for Mounting

Holes/Cord Entry

Template Shown Actual Size

2.21

1.085

1/4” DRILL

1.48

0.73

2xШ3/32”