SoundOff Signal GHOST Rock Light (10-30 vdc) User Manual
Warning, Ghost® single rock light
1.800.338.7337 / www.soundoffsignal.com
IMPORTANT INFORMATION:
Warning devices are strictly regulated and governed by Federal, State and Municipal ordinances. These devices shall be used ONLY on approved vehicles. It is the sole responsibility of the user of these devices to ensure compliance.
To review our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product, visit our website at
www.soundoffsignal.com/sales-support.
If you have questions regarding this product, contact
Technical Services, Monday - Friday, 8 a.m. to 5 p.m. at 1.800.338.7337 (press #4 to skip the automated message).
Questions or comments that do not require immediate attention may be emailed to
SUPERIOR CUSTOMER RELATIONSHIPS. SMARTLY DESIGNED LIGHTING & ELECTRONIC SOLUTIONS.
• Warning devices are strictly regulated and governed by Federal, State and Municipal ordinances.
These devices shall be used ONLY on approved vehicles. It is the sole responsibility of the user of these
devices to ensure compliance.
• DO NOT install this product or route any wires in the Air Bag Deployment Zone. Refer to your vehicle
Owner’s Manual for the location of any air bag deployment zones.
• DO NOT connect this device to a strobe power supply. This product is self-contained and does not
require an external power supply.
EGHST3(x) 07.14
Important Information:
OPERATION:
WIRE CONNECTIONS
See setup procedure on second page.
The single GHOST comes equipped with
an internal flasher with 33 user selectable
patterns that can be synchronized either
alternating or simultaneous with up to three
other lights. It can also be put into slave
mode and driven through an external flasher.
1. Connect the GHOST BLACK wire to a
good, convenient ground.
2. Connect the GHOST RED wire to one side
of a user supplied on/off switch. Connect
the other side of the switch, through a
5Amp fuse, to a source of +10-30Vdc.
NOTE: The GHOST is a factory sealed unit
that CANNOT be serviced in the field. Any
attempt to gain access to the GHOST unit
will most likely cause permanent damage
and void its warranty.
INSTALLATION:
Establish a flat position on the vehicle.
D
rill a
9/32”dia.
hole in the center of
the mounting location. Attach bracket
as shown using external toothed
washer. Note: if 2 bolts are desired for
attachment, holes should be 2.5” apart.
Only one bolt is furnished.
Thread cable through center hole and
screw light to upper bracket.
DO NOT
OVERTIGHTEN.
Place toothed washers over studs and
insert one stud in slot. Install outer
washers as shown and secure with
nuts.
Make electrical connections.
GHOST® SINGLE ROCK LIGHT
EGHST3(x)
WIRE HOOK-UP TABLE
WIRE COLOR:
CONNECT TO:
RED
+10-30Vdc
BLACK
Ground (-)
WHITE
Pattern Select
This product contains high
intensity LED devices. To prevent
eye damage, DO NOT stare into
light beam at close range.
WARNING
!
TECHNICAL
SPECIFICATIONS
Overall
Dimensions:
4.77”L x 1.98”H x
1.62”D
Input Voltage
Range:
10-30Vdc
Current
Consumption:
# of LEDs: 6 Generation 3 LEDs
Operating
Temperature:
-20º to +65º C
# of Flash
Patterns
33