SoundOff Signal Taurus-Intersector Compass Light - Manual

1.800.338.7337 / www.soundoffsignal.com
ECPNTKF1B(xx) 11.12
Fig. 1 - Fender Light pre-assembly -
-View from outside of fender-
#6 Torx
Screws 2x
Mounting
Bracket
Intersector
Light Assembly
(place with label facing down)
Trim Panel
UP
UP
Fig. 2
INSTALL
CLIP NUT
#8 Phillips
INSTALLATION:
1. Remove the vent panel from the vehicle
per manufacturers instructions and install
the supplied clip nut onto the fender of the
vehicle. Figure 2.
2. Slide the Intersector Light Assembly into
the Trim Panel making sure the label is
facing down. Figure 1.
3. Run the Intersector Light cable through the
wire hole in the mounting bracket as
shown in figure 1.
4. Install the Mounting Bracket on the back of
the Intersector Light and the Trim Panel part
as shown. Figure 1. Use the 2 supplied #6
Torx Screws to attach the Mounting Bracket
to the Trim Panel. Tighten Snug. Figure 1.
5. Run the cable assembly into the fender and
install to the power source. See page 2.
6. Snap the Compass Fender Light assembly
to the fender opening.
7. Secure the assembly with the supplied #8
Phillips screw (one per side). Figure 3-4.
Wire
hole
Fig. 3
! WARNING
This product contains high intensity LED devices. To
prevent eye damage, DO NOT stare into the light
beam at close range.
OPERATION:
For details on operation see page with ‘Flash
Patterns’ table on last page.
WIRE HOOK-UP TABLE
WIRE COLOR:
(ALL WIRES 20ga)
CONNECT TO:
(FROM FLASHER ONLY)
RED +10-16 Vdc
WHITE Pattern Select / Sync
BLACK
Ground (-)
GREEN
Cruise Mode
(+10-16 Vdc)
IMPORTANT:
Power should only be
supplied through RED
WIRE of flasher harness
and must be fused with
a 3A, user supplied,
in-line fuse. Failure to
install this fuse will create
a fire hazard and will
damage the Intersector™
Light. Connecting the
Intersector™ light to any
power source directly
WILL permanently
damage the light and will
void warranty.
IMPORTANT! FOR
PROPER OPERATION
ALL WIRES MUST BE
CONNECTED FROM
FLASHER TO LIGHT
HEAD.
GREEN BLACK RED WHIT
E
1 3 2 4
1 3 2 4
GREEN BLACK
RED
WHIT
E
FEMALE
CONNECTOR
MALE
CONNECTOR
FROM FLASHER
INTERSECTOR
LIGHT
ALL WIRES 22ga
COMPASS FENDER LIGHT
ECPNTKF1B(xx) - FORD TAURUS
All 5 Mounting clips must rest on
inside edge of body opening. Press
firmly to ensure all 5 clips are engaged.
Fig. 4
-View from inside of fender- Secure assembly to clip nut
REMOVAL PROCEDURE:
1. Unclip the bottom 2 mounting clips using a
small putty knife to disengage the mounting
clips.
2. Rotate light assembly and lift off.